Levelling
Level the washing machine by loosening or tightening
the feet. Once in the right position fix the feet by
pushing the nuts against the base of the case.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation. After
levelling the machine, secure the feet by tightening the
ring nuts with the aid of a screwdriver.
Some vibration is inevitable, especially if mounted on a
P0254P0509
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
If the machine is situated on a carpeted floor, the feet
must be adjusted to allow air to circulate freely under
the machine.
Special conditions
If the floor is carpeted with a deep-pile carpet or
covered with crumbly or soft material, insert a rigid
support base under the feet to prevent noise, vibration or
displacement. The base should protrude a few
centimetres beyond the edges of the machine.
Warning
The machine should NOT be placed on deep pile
carpeting.
Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
In the interest of the
environment
Washing machines and dishwashers should be
connected to the FOUL drainage system, the water will
then be taken to a sewage works for treatment before
SHOWER
being discharged safely into a river.
SINK TOILET
BATH
It is essential that these appliances are not connected toBIDET
the surface water drainage system as this water is
discharged directly into a river or stream and may causeWASHING
MACHINEDISHWASHER
pollution.RAINWATER
'RUN-OFF'
If you require any further advice please contact your
FOUL DRAIN
local authority drainage department.SURFACE WATERFOUL SEWERS
DRAINS & SEWERS
SEWAGE
UNTREATEDTREATMENTWORKS
DISCHARGE
TREATED
DISCHARGE
RIVERRIVER
P0987
9 |